A manufactured home is built with lighter framing and thinner floor decking than a site-built house, so water that gets in can reach the structure quickly. Leaks from a supply pipe, a water heater or an air handler are the usual starting points, and the damage often hides under flooring and inside wall panels. Because the floor sits above open space, water from a leak can also drip into the insulation under the home and stay there unseen.
Where water hides
- Floor decking under vinyl and carpet
- Insulation under the floor
- Wall panels near bathrooms and kitchens
- Ceiling panels below roof seams
- Cabinet bases along exterior walls
Water under the floor or in a wall of the home? Call and describe it, and the crew will say what to shut off first.
Call about the home leakDrying with care
Decking and panels can swell, delaminate or soften if they stay wet, so readings decide how much is opened. The crew often cuts small access holes to dry cavities with air movers instead of stripping whole rooms, and checks under the home for wet insulation. Moving air through a closed cavity works slowly, so readings are taken daily and the equipment is adjusted rather than left alone.
Repair planning
Once decking and framing read dry, a contractor can repair floors and walls. For a first extraction pass, see water extraction in Mascotte, and for the drying standard, read structural drying.
Heater leaks are covered under water heater leak cleanup.
Manufactured Home Water Damage in short
Manufactured home leak cleanup for Mascotte: floors, walls and decking are checked, opened only where wet, and dried to meter readings with care for the lighter structure.